Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is on a Nexus 7700 version 6.2(10) For security reasons we have some L3 OSPF SVIs configured as passive interfaces. However, I have a network tool (it maps and analyzes the OSPF routing world) that must form an OSPF neighbor adjacency with anot...
I have an old ACS 4.2 running on an old Windows 2003 Server. I have to move it off the Windows 2003 Server due to security reasons. I know that 4.2 is not supported any longer. Unfortunately, I don't have the time right now to migrate from 4.2 to ...
We have some 6880 VSS pairs that have several 6800IA-48FPDRs and 6880IA-48TDs connected to them and I'm getting ready to upgrade the IOS using ISSU. I want to upgrade the 6880 VSS pairs first and not have the 6800IAs automatically upgrade all at once...
.... as show in the entries below:*Feb 28 16:00:45: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/2, changed state to up.Sep 16 06:28:01: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 164.72.58.198 Port 514 started - CLI initiate...
DHCP Snooping best practice states to store the snooping database remotely in case of a catastrophic failure of the access switch. We are getting ready to implement L2 security on our access switches (about 100 of them) and it seems that if we have e...
I figured out why the GE port doesn't allow for 'ip dhcp snooping trust'. Only an L2 port can have dhcp snooping trust on it - an L3 port doesn't have that option. I had an IP address configured on the GE port, therefore no snooping trust option wa...
The ASR1006 doesn't have the command 'show controller ethernet-controller....'. I did find this command though:TSC-ASR1006-A#sh platform hardware port 0/2/0 plim statistics Interface 0/2/0 RX Low Priority RX Drop Pkts 0 Bytes 0 ...
Here is the output of 'show interface' you requested. I did it again a couple seconds later to show the input frame errors increasing. TSC-ASR1006-A#sh int g0/2/0GigabitEthernet0/2/0 is up, line protocol is up Hardware is SPA-2X1GE-V2, address i...
