Hi, I need to custom a report with NAM Traffic Analizer to measure bandwidth usage "by network" ...  not "by host or IP address or application".  Only "by network".<br />Is it possible to do that ??

Hi, I have tested many SNMP softs and tools. Already I have compiled CISCO MIBS.But the problem is I can't use ciscoPingMIBObjects because the remote routers c1811 reject the request. I don't know how to upload ciscoPingMIBObjects into these routers....

Is possible to register a c2600 with FXO ports to a gatekeeper ?When I do "sh gatekeeper endpoints" the gatekeeper shows the registration BUT whithout the numbers of c2600 potsAlthough I can register the same router with the same configuration using ...

Hello, could somebody to tell me the way that the ATA 186 users can dial any numbers without restrictions and send these numbers towards gateway without concerning the amount of dialed digits?And then I need that gateway (c2610) accepts those numbers...

How to configure a codec−class on the gateway to negotiate the second call using G.711 when G.729 is the default codec used???.I know in simultaneous dual-port operation, the second port is limited to G.711 when using G.729. Without this configuratio...