Hi,I am running IPv6 over MPLS (not 6PE) but I cant see the bindings using "sh mpls ldp bindings" nor the forwarding info using "sh mpls forwarding-table", are these commands IPv4 only?I can try: sh ipv6 cef, which gives me the info but in a differen...

Hi!,I have two TE tunnels for the same destination and I would like to send traffic to one or the other based on it ip DSCP field.?does someone has any link to similar configs?Regards,Roque

Hi,Anybody knows if it is possible to configure ssh (client and server) at the PRP2 Ethernet ports using private IPs for a GSR router?.do this ports share the routing table of the rest of the GSR?Any security recommendation when using these portsThan...

Hi,Is it possible to configure VRF-lite in a QinQ trunk in Cat 6500 e/w SUP-720?Regards, Roque

I am a little bit confused when we talked about inter-area TE and L1/L2 ISIS routers.I have 8 L1/L2 routers in a partial mesh, these routers belong to different ISIS areas.As I understand ISIS implements a topology table for the L2 routes and thus a ...