Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Since upgrading firmware, on each boot the router automatically turns on debugging, and it has to be manually switched off using the "undebug all" command. How do I stop this from occuring?
I've tried this via SDM, used several configuration guides and looked at this forum for help, but I still can't get this to work properly.Either I have a wireless connection that a client can connect to, but can't get an IP from, or I follow the guid...
I have been trying to get this router setup properly for a few days now, and realised that not knowing IOS is a big disadvantage as SDM is perhaps "flaky".So far I have managed to get ADSL over POTS by sending over "ppp pap sent-username user@domain ...
Thanks for the reply.show version:Cisco IOS Software, C870 Software (C870-ADVIPSERVICESK9-M), Version 12.4(15)T3,RELEASE SOFTWARE (fc1)show debug:dot11: dot11 Syslog debugging is on
Hi,So far I have the network up and running, just need to set up a static dhcp assignment for a clinet by MAC address so that I can assign forwarded ports. Here is my current configuration.
