In order to run the 1522 APs, you will need to use the mesh code. I know that it is a hassle, but it is not recommended to run both mesh and non-mesh aps on the same controller. You would need two separate controllers. The only controller that will...

Have you tested the cable with a volt meter? Set the volt meter to Ohms and test the center pin on each end, the outer connector on each end, and then the center pin and connector. Do you have a lightning arrestor installed? Make sure that the groun...

I just fixed a similar issue with a 1242 yesterday as well as having run into it in the past. There is a known issue with AP 1200s when using PoE from a switch. I would have to do some digging to find the documentation, but the AP will power up and...

Make sure that you have plenty of ventilation around the unit. If it is sitting on top of switch or another controller, it WILL get hot. You may need to raise it up a few inches or put it on a shelf of it own to get a little more air flow around it...

Generally speaking, you would want to set these up for full diversity (tx and rx on both antenna ports) to reduce multipathing and achieve the best range possibe. You would also want to set these antennas at the proper distance apart to avoid further...