Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I can't seem to access our catalyst 4006 after enabling AAA for radius. I have setup IAS on our domain controller and setup a the catalyst as a Radius client as well as configured a remote access policy that points to an AD group to allow switc...
Hello,I am having some issues with an ACL I'm trying to create for guest internet access at our sites. We have a separate VLAN (10.100.206.x) for the guest access and I have assigned the ACL's to the VLAN interface. I have attached a list of the acl ...
Hello,Another technician and myself are scratching our heads over an issue at one of our remote school sites. We have blocked access to the 189.0 network so they cannot access the web or the rest of the WAN and only access local servers. The 199.0 ne...
Hello,We have just started to integrate a new 3 point metro-e wan connection to our main school office. I have attached configurations from both the main and remote site as well as a basic diagram of how everything physically connects. The problem I ...
Just a quick question if anyone knows here. We are looking for a WIC Ethernet card for a 2620 router. Some websites I have visited have said the WIC-1ENET will work on the 2600 series while other say it only works specifically on the 1700 series. Not...
Here is a full config file minus the list of Ethernet ports. As I said in my last message I have the settings IAS server for this catalyst pointed to vlan 10. (10.100.49.1)Tim
I do not see any hits at all on the IAS logs. It's as if the switch will not communicate with IAS. I've tried a different key as well, something simple so I know I wasn't typing it in wrong. Do I need to specify a different address on the IAS server?...
"why on "main" you have 10.100.171.1 defined both on FastEthernet3/20 and vlan1 as a secondary?"Look again... Vlan 1 has 177.1 as a secondary not 171.1. 177.1 is a network at our main site."why is "remote" GigabitEthernet3/3 defined 10/full while "ma...
We are running eigrp across the board so if it's a routing problem either I have set the wrong statement or my eigrp statements are wrong.Keep in mind all of this is live and working over our existing T1 but when we try to cut over to the metro-e, we...
