Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running a stack of Catalyst 3750's in a large office. I often find that ethernet ports are patched to desks that end up not being used for long periods of time. We end up with hardly any free switchports and it becomes a very manual job to find ...
I have a Cisco 3750 switch with the following VLAN's2 - Engineers3 - Automation Dept4 - AN Other Company5 - Guest AccessI have an 1131ag connected to the 3750 and I have setup a dot1q trunk on the swithchport that connects to the AP.http://www.cisco....
I thought i'd ordered an 1130ag but it looks like i've ordered an 1131ag LWWAP.Please could someone tell me what the difference is between an 1130 and 1131. Also I understand I can load IOS software on the lightweight AP using a tftp server but I'm n...
I have setup a VLAN on our stack of 3750's for use by guests connecting to our guest wireless network. An ACL enforces that they can only access our proxy on port 80.Is it safe to let them use DHCP to get an IP from our DHCP server on our corporate L...
Here's what I do. I can't remember the commands but i'll look them up if you need me to. Say your WAN connection is on fa0/1 and your pc is on fa0/2. You can set the switch to send all the frames that would be destined to go out via fa0/1 to also go ...
I assume you have the 4500 series then. I'm no expert but I would assume you would always look at the input (ie frames from host to switch) but why they should differ by that much time I don't know.So it's looking like there is no command in the IOS ...
ok i'll give that a go now. I don't have any member ports on VLAN1 on the switch but I'll set the dot1q trunk to have have VLAN1 as the native VLAN. was a bit confused as to why i needed to have vlan1 on the trunk if no other ports are a member of th...
