About ravichandrantg

ravichandrantg · 08-30-2007

Hi,I have taken an MPLS connectivity between two offices and would like to deploy backup Leased Line connectivity through other ISP.I have configured static route for both the links. MPLS with High priority and Leased Line with slightly lower value...

ravichandrantg · 08-29-2007

Hi,I have an MPLS connectivity between two branches. I have created a tunnel between two router interfaces.I would like to configure priority queining on the Tunnel interface. (with acl defined priority groups high/medium/low/normal) Is there a way t...

ravichandrantg · 08-29-2007

Hi,I have currently configured priority queuing with high,medium,low and normal criteria matching accesslist on my serial interface connecting a remote site.The current bandwidth on the serial LL is 1 Mbps, i would like to reduce the same to 512 Kbps...

ravichandrantg · 07-19-2007

Hi,I configured priority queuing on my Cisco 2800 serial interface.Four Queues high ,medium,normal,low were assigned a queue size and mapped with an individual access list.I would like to monitor the packet drop rate at individual Queue using by Nms ...

ravichandrantg · 09-04-2007

Hi,Yes talking to Solution provider for routing protocol is an option.But the best solution i feel is to create a Tunnel across both the routers for the MPLS Link and then run a routing protocol.I did the same in my environment.RegardsRavi.

ravichandrantg · 08-30-2007

Thanks , this exactly match my requirement

Member Since	‎07-19-2007 01:35 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	7

User Statistics

User Activity

Route availability Problem in MPLS

Qos configuration on Tunnel Interface

Qos configuration with Rate-limit

Snmp oid for Qos

Re: Route availability Problem in MPLS

Re: Qos configuration with Rate-limit