Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I change the MAX Association number of the clients using SNMP. When i do this the AP disconnects all the clients! Is it necessary or i have a wrong firmware version.
Hello,I have used the command snmpset to change the properties of my ap.After that, i got the following message:Notification: Interface Dot11Radio0, changed state to reset.When the AP resets its state, all the clients are disconnected. How can i avoi...
I have the following problem with my APs. I use snmpset to change an object's value. I set the new value succesfully, but when i try to get the new value the snmp agent returns the old value.setting....root@teo:/home/teo# snmpset -v 2c -c demopubli...
Cisco Aironet 1200 Firmware 12.3(8)JEBHello,I want to control client associations when AP load is high.Is there an MIB object that enables/disables client associations?I have searched the supported MIBS, but i could not find anything.
(firmware 12.3JEB)I want to distinguish if an AP is in 802.11 a or b / g mode.I have tried to get specific information from AWCVX-MIB.my.For example i have tried to read AWCVX-MIB::awcDot11CurrentCarrierSet,AWCVX-MIB::awcDot11CurrentChannelobjects bu...
Hello again,Yes it's my mistake,the AP restarts for the new changes to take effect.It doesnt reset.Particularly i change the MAX Association number of the clients using SNMP.When i do this the AP disconnects all the clients!Is it necessary or i have ...
Hello,I still can't get the information from the above MIBS...SNMP Output(For 3 connected Clients) - Cisco Aironet 1200 firmware version-->12.3JEBCISCO-DOT11-ASSOCIATION-MIB::cDot11ClientRadioType.1."gstam-cisco".'.....a' = INTEGER: unknown(1)CISCO-D...
Hello again,I have found what i needed.CISCO-DOT11-ASSOCIATION-MY.myObject : cDot11ClientCurrentTxRateSetThis object gives the information about the current rate that the access point sends data to the client.I have tested this and it's correct. T...
