Aironet 1200 Interface changed state to reset
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-24-2007 11:56 PM - edited 07-03-2021 02:40 PM
Hello,
I have used the command snmpset to change the properties of my ap.
After that, i got the following message:
Notification: Interface Dot11Radio0, changed state to reset.
When the AP resets its state, all the clients are disconnected.
How can i avoid the reset of the AP?
I want to make changes dynamically - and also i want my clients to maintain their connection.
- Labels:
-
Aironet Access Points
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2007 08:21 AM
When changes are mode to AP it is bound to restart for the new changes to take effect. But it shouldn't reset. Then this is probably an issue with the firmware. Try to reset the AP using Mode button . Before you do this back up your configurations. Last resort would be to upgrade the AP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-06-2007 05:21 AM
Hello again,
Yes it's my mistake,the AP restarts for the new changes to take effect.It doesnt reset.
Particularly i change the MAX Association number of the clients using SNMP.
When i do this the AP disconnects all the clients!
Is it necessary or i have a wrong firmware version.
