Hi allthe scenario is ASA-- --R1(Public subnet 1)--- -------Switch---------------------ISP1ASA-- --R2(Public subnet 2)---What is the best way to achive the redundancy both the firewalls in active active mode connected to switc...
HI allI am lookinf for things to be consider before IP renumbering in data ceneter. Is there any checklist availabe for that or any best practise.Thanx in advanceRegardsanand
HiThe HSRP preemption feature enables the router with highest priority to immediately become the Active router. Priority is determined first by the priority value that you configure, and then by the IP address. In each case a higher value is of great...
Hi Well the "switchport trunk valn vlan list" only allowed the trafic for specific vlans that u add to the vlan list in the above commant where as if enable the vtp prunning that only forward the traffic if same vlan exist on both the swith for eg. i...
Hi Alan I m not sure y frames are untag frames send for native vlan.But you can change the native vlan with simple command that is switchport trunk native vlan
Hi deari was just going through rfc 2328 that is of ospf and i found that In order to make the transition to a new Designated Router smoother, there is a Backup Designated Router for each broadcast and NBMA network.well might be this is...
