About ropethic

ropethic · 08-16-2010

Trying to determine when I perform show standby the following appears:GigabitEthernet0/1 - Group 2 State is Active 264 state changes, last state change 00:47:43 Virtual IP address is 10.2.5.1 Active virtual MAC address is 0000.0c07.ac02 Loca...

ropethic · 08-26-2008

c3750E booting off wrong IOS image and need to know how to enter break sequence to get to rommon. Can someone send me the procedures. I am using hyperterminal on xp laptop. Tried ctrl c shift, ctrl fn breaknothing seems to work

ropethic · 06-19-2012

From what I am being told, pretty much all versions from 4.1 should be able to be upgraded to 5.0. Again, I would wait for the release notes to be posted to check on firmware and supported previous versions

ropethic · 06-19-2012

Dan Version 4.5.1 is not posted to CCO and is delivered to customers via request from their Cisco account and support representatives. This was due to the scheduled release of 5.0 next month which will include the ICA Layer 7 optimizer as well as enc...

ropethic · 06-18-2012

Dan From release notes When you upgrade to Version 4.5.1, observe the following guidelines and requirements: •Upgrading to Version 4.5.1 is supported only from Versions 4.1.1d, 4.1.3, 4.1.3b, 4.1.5c, 4.1.5f, 4.1.7, 4.1.7a, 4.1.7b, 4.2.1, 4.2.3, 4...

ropethic · 06-18-2012

Brent,First I would recommend viewing the WAAS Troubleshooting guide: http://docwiki.cisco.com/wiki/Cisco_WAAS_Troubleshooting_Guide_for_Release_4.1.3_and_LaterWithin you will find a section detailing TFO overload conditions. Perform a show statistic...

ropethic · 06-18-2012

Put a sniffer on the application user workstation interface (SPAN) and capture transactions over a gievn time period. This will provide the average BPS and tell you how much bandwidth the applicaiton is using.

Member Since	‎07-28-2006 04:31 PM
Date Last Visited	‎03-03-2021 12:38 AM
Posts	303
Total Helpful Votes Received	167

User Statistics

User Activity

Standby Router is ICMP?

3750 Escape sequence

Upgrading WAAS best Path to 4.5.1

Upgrading WAAS best Path to 4.5.1

Upgrading WAAS best Path to 4.5.1

WAAS Express sizing -vs- WAAS Appliance sizing

Application bandwidth requirement