Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,While deploying WAAS,i ran into some problem with one of the edge WAE,it has constantly shown its CMS status as offline.The problem is it comes online then goes offline almost immediately.Whats more is that i can't telnet (I can ping it though)to ...
Hi,There is WAAS demo we are doing for one of our clients,The whole set up appears to be working ok,From the central manager its evident that there is compresion/optimization.The problem however is that the client is using ping results as a benchmark...
Hello,I have been doing a CME deployment and ran into some problem with the 7914 expansion module on the receptionist's 7961 phone.I have the following file in flash-S00105000300.sbnI also have the following configurations:tftp-server flash:s00105000...
Hi all,My set-up is one like this:Ip phones are registered to a cisco callmanager,an H3.23 gateway is also registered to the same callmanager-the gateway is a cisco 2821 cisco router-which has a number of FXO ports where the pstn providers have termi...
Hi,I recently bought a 7931 and am using it with callmanager ver 6.The problem is that the transfer button on the phones just dont come on.I have tried all manner of softkey configurations but the key is not coming on.It is so bad because it is a sec...
Hi,At that time it worked,i was actually missing some configurations both on the callmanager and the voice gateway.I ran into some problem which remains unresolved to date.Please refer to this conversation:http://forums.cisco.com/eforum/servlet/NetPr...
Hi all,Very many thanks for your input(s).One problem is:the voice gateway is in Rwanda while am in Kenya and so most of the time i have to get the support guy on the phone and tell him to input the commands as we test-so far we have taken out the ca...
Thanks for that,However,this is the first thing that i tried out,I picked an analog phone connected it directly to the FXO ports and tried making a call and it was going successfully.So to me,the provider was out of question.
I applied both of these configs on the Voice gateway and nothing much changed,when you pick a phone and dial a PSTN number,the noise is still there(the noise is one like this:dooooo..h).I have never seen such a thing before.am using the route pattern...
