frsisqo14344
Beginner
Beginner
Member since ‎10-26-2011
‎08-18-2017

User Statistics

  • 18 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hi All,We have a publisher and a subscriber and 2 offices. Currently all phones are registered to publisher. How do i force 1 office to register to publisher and the other half to register to subscriber? CUCM version is 8.5Thanks
Hi All,is 633+ seconds (approximately 10 minutes) load time normal for a Cisco 7204 router? I find that it takes forever for the router to do :Self decompressing the image". I tried the latest IOS and tried different bootloaders but it doesnt seem im...
Hi Everyone,Is placing the CUCM pub or sub and SRST in the same network recommended? Are there any best practices for this configuration? basically, I want to place the publisher and the srst on the same network and location and the subscriber on ano...
Hi how do you configure BGP in the below scenario?R1/R2 = Customer RouterISP1 ISP2R1 connected to ISP1 and ISP2, R2 to ISP1 and ISP2, R1 connected to R2. So far most design and configuration I have seen is R1 to ISP1, R2 to ISP2, R1 to R2.Thanks
Hi Everyone,Got 4 3550s running ospfR1 fa01 is connected to R2 fa01R1 fa02 is connected to R3 fa01R2 fa02 is connected to R4 fa01R3 fa01 is connected to R4 fa01and configured as trunk also running HSRP when i disconnect R1 to R2, traffic does not go ...
Community Statistics
Member Since ‎10-26-2011 06:40 PM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 18