Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So, I have an interesting (and very frustrating) one for you guys. I am using CME with Broadvox for a SIP trunk provider and have 7975g phones internally. I would like to have them use G722 on any call where it's possible and G711 on all other call...
Hello everyone. I have recently decided to get in to Cisco's phone offerings with my ISR2 (2911) and have been looking to integrate Exchange 2010 UM with CUCME. Setting up the dial peer was easy, as was getting the phones to register via SIP and pr...
Hello everyone I am having some issues with IOS 15.1.3T on a 2911. I'm by no means a Cisco expert and am trying to teach myself the ins and outs of IOS but am having some difficulties that I am hoping someone can help me out with. The first issue ...
Does anyone have any idea why the IPv6IP tunnel mode would be unavailable on a 2911 running 15.1.3T? Does this tunnel mode require a special license or is the Base IP license enough for it? As I understand the documentation I've been able to find, ...
I'm relatively new to Cicso hardware but have been in the IT community for over a decade and I am a little perplexed as to why this router is doing what it is. Here goes..I have a 2911 configured to connect to the Internet on gig0/0 with DHCP enable...
So, I decided to go ahead and buy quite a few 9951s and set them up for use, only to find that they're worse than the SIP builds for the 7975s. In addition to the G722 issues I describe in my posts with the 7975s, they also have major problems with ...
BrianBelow is from using a SIP build. It does offer G722, but it's way down on the list so it's never used...m=audio 32678 RTP/AVP 0 8 18 102 9 116 101a=rtpmap:0 PCMU/8000a=rtpmap:8 PCMA/8000a=rtpmap:18 G729/8000a=fmtp:18 annexb=noa=rtpmap:102 L16/1...
I too would like to know if this is possible and how to do it. I look every so often to see if anybody has posted anything, but haven't found anything to date.Marcus, have you been able to figure it out since you posted this?Anybody who is a Cisco w...
Ok, so I figured it out though I don't understand why it doesn't work as expected... If you change the "dns:" in the mwi-server command to "ipv4:255.255.255.255," it works great. I'll have to follow up later on this but at least I know the configur...
