Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I just installed and configured a brand new WLC 9800L and when a new 2800 AP tries to connect I get this message on the WLC: [CAPWAP-IDB Error : 420010 - GET SWIDB : Search failed for iifid[Count : 0] WLC is running 17.3.32800 is 8.10.130.0 Whe...
Hello,
I have two 2504 WLCs both running 8.0.152.0 in two different sites connected via an MPLS network with no Firewalls in between and both WLC have the same virtual address (1.1.1.1).
Both WLC are on their local mobility group and they work correc...
Hello, I have a new 4500-x running IOS-XE version 03.03.00.XO RELEASE SOFTWARE (fc2)ROM: 15.1(1r)SG2.it has a dual supervisor and it is configured as a simple switch (all ports on the same VLAN) and if I connect two pc on any port and I start ping...
Hello,I'm running VPN SSL on an asa 5520 (V8.2.5) with LDAP authentication and everything works fine but now the AD people changed name in the groups and they added a " " "blank" in one of the fields so when I configured the group I get an err...
Hello, yes, the AP with static address can ping the WLC. and the WLC can ping the AP.I'll enable DHCP option 43 although I don't see the need as the AP has a fixed ip address an it is in management vlan. I'll keep you updated.Giovanni
Hello All,the ntp is correctly configured and the WLC is in sync with it.DHCP is not used as I manually set ip address/mask & primary controller in the new APthe wireless management interface is defined on the WLC.... Is there a debug command I can i...
Hello Marcel,thanks a lot for your reply! I've attached the console cable to the AP and this is the result: [*05/22/2021 00:29:53.1436] DOT11_DRV[1]: DOT11_DRV[1]: set_channel Channel set to 36[*05/22/2021 00:29:54.0300] DOT11_DRV[0]: DOT11_DRV[0]: s...
Hello,
thanks for your reply, actually the issue was on my side as I misunderstood the docs.
At the end I was able to setup the right configuration.
Franco
Hello,
the aim is to setup a mobility anchor but, I guess, I have to put the two controllers in a common mobility group first.
I've enabled debugging on the remote WLC and I get a Mismatched mobility group...
*mmListen: Nov 20 15:55:34.216: Mismatc...
