hi, i have configured the router to dial PPPoE connection and do natting & routing:ip nat inside source route-map Connection_1 interface Dialer1 overloadip route 0.0.0.0 0.0.0.0 Dialer1route-map Connection_1 permit 10 match ip address 1 match interfa...
hi,can someone post a sample configuration for combining 2 ADSL lines using (ppp multilink).i have 2 adsl lines from the same ISP, each one negotiates diffrent IP, but i can get them to have the same ip if this is requires, and my ISP support MLPPP.i...
hi,i have this configuration:!interface FastEthernet3/0 ip address 10.0.0.1 255.255.255.0 ip nat inside ip tcp adjust-mss 1452 duplex auto speed auto pppoe enable pppoe-client dial-pool-number 6 pppoe-client dial-pool-number 5 pppoe-client dial-pool-...
Hi, i have multiple DSL lines, and doing load balance over all the lines, i.e.route 0.0.0.0 0.0.0.0 Dilaer1route 0.0.0.0 0.0.0.0 Dilaer2and so on,i would like to route SSL traffic to only one dialer, any idea where to start?thank you.
hi, thanks for reply, here is the ansowers:access-list 1 permit 192.168.1.0 0.0.0.255dialer-list 1 protocol ip permitRouter Cisco 3845the load is not that much, i am currently the only user using it for testing.cpu < 1% utilization, and memory is alm...
hi, i did some comparision between my 2 fast eth, there is only one diffrence that i found:Router#sh int fast3/0 switchingFastEthernet3/0 Throttle count 0 Drops RP 0 SP 0 ...
hi thanks,no it wont be removed!i tried shutting the interface then no pppoe-client dial-pool-number 4, it wont be removed.i tried no pppoe enable, then all of the dial pools has been removed, but when i enable it again by pppoe enable, all the pppoe...
