10-18-2007 12:00 AM - edited 03-05-2019 07:10 PM
hi,
can someone post a sample configuration for combining 2 ADSL lines using (ppp multilink).
i have 2 adsl lines from the same ISP, each one negotiates diffrent IP, but i can get them to have the same ip if this is requires, and my ISP support MLPPP.
i have both PPPoA and PPPoE. (ATM interface, and Ethernet with bridged modem), i can use any.
thanks.
10-24-2007 05:34 AM
You can load share dual-homed to single Internet Service Provider (ISP) Through a Single Local Router . For more info : http://www.cisco.com/en/US/tech/tk365/technologies_configuration_example09186a00800945bf.shtml
10-24-2007 05:45 AM
i am looking for a simple mlppp on a dialer interface, someone with sample config please?
10-24-2007 10:56 PM
Hi
Though you think off bundling and using i dont think your SP will be able to authenticate both ur user id credentials supplied by a single dialer interface which i dont think is not possible.
Instead you can think of availing maximum simultaneous session as 2 for your single user id which could help you to have 2 logical pipes open for forwarding your traffic.
This is very much possible with normal plain old isdn dialups may be you can check out this with your isp.
regds
10-25-2007 12:39 AM
my ISP is giving me whatever i want!
just please help me with this config!
thanks,
10-25-2007 12:58 AM
Hi
I intend to convey the below in my earlier post...
"Though you think off bundling and using i dont think your SP will be able to authenticate both ur user id credentials supplied by a single dialer interface, which i dont think is possible. "
regds
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide