Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I am studying for my CCNP and have had a few questions that have been helpfully answered by people here. I am very grateful that you all are here and that you share your expertise. So . . . thanks and cheers for that.The question I h...
Hi everyone,I have a home lab setup with three 3640 routers, easily named and connected as "Top", "Left", and "Right". They are connected in a triangle, with the top router on the top and the other two on the bottom. Each router has 2 serial cables c...
Hi Everyone,Can anyone give me some information on setting up NTP in a home lab - I have been trying to get it working forever, but nothing seems to work.I have three 3640 routers and a Win laptop connected to a Catalyst switch. Using the "ip helper...
Hi All, I have two newly purchased (and very used) Cisco 3640 routers - each has a 2E2W Network Module and one WIC 2A/S. I can see both WIC 2A/Ss when I run a sho diag command, but I cannot confiure them as serial ports and do not see them in an...
Hi all,I'm a CCNA who has spent some time away from the gear, and am getting back into it. Just purchased two 3640 routers and a 2950 Enhanced Image switch to practice/learn/relearn. Running into a problem that I'm sure is very simple, and feel ver...
Hey - a fellow CCNP student! Very cool. I plan to take it the following friday, July 18th, actually. I am dreading it too, but not nearly as much as I was before. I know my weaknesses - Multicast, IPv6, ISIS, and redistribution (a little weak, fo...
Thank you for replying, and thank you for the link. The redistribution described uses distribute lists to avoid routing loops . . . My question was actually whether it would be useful to be able to "set" the Administrative Distance via a route map w...
Reply to your response:Hi Hennigan,I'm sorry if I wasn't clear before. The loopbacks are not part of the OSPF process, they are in fact part of the RIP network. So the left loopback, the right loopback, and the Serial connection between the two rou...
Hi Hennigan,Thanks for your reply. I have just reconfigured my routers for the OSPF/RIP redistribution, and will try out your suggestions. Thanks for your help - will post my results forthwith (heh).Thanks, and cheers.Jim Woodward
Hi Rick,Thank you so much for your help. I had wiped the configs on the routers clean to follow along with some other exercises. So I just set the network back up to run NTP, and started troubleshooting at the PC first. I discovered that the Netwo...
