Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there.I have a customer that runs two ASA devices (Version 7.2(2)) in failover scheme, and several users that connect to the network using VPN Clients with different versions. Actually, just a few users have been facing a weird problem, when they ...
Hi there.I have a 2611 router, IOS version 12.3(25), configured as an VPN server. I have already configured the IP Sec parameters, users...and it is all working fine. But my customer needs to limit the access of one user that uses the same group and ...
Hi there.I have a 2611 router, IOS version 12.3(25), configured as an VPN server. I have already configured the IP Sec parameters, users...and it is all working fine. But my customer needs to limit the access of one user that uses the same group and ...
Hi.Check again your settings on both interfaces. The configuration on ports that belong to a Etherchannel group need to have exactly the same configuration. Speed, duplex, link type, native vlan, etc.If a port are with just one of these parameters di...
Hi Rich.You just need to open the file .jar with the WinRar; download here:http://www.rarlab.com/download.htmWhen you extract the files inside the .jar archive, you will see the startup config saved in there, so you just need to open it with the Word...
Hi Jorjes.Try to boot the switch just with the supervisor inserted, without the GBIC modules inserted and no other cards. If the switch does not work well, try to load the IOS again and squeeze the flash. If the switch starts to work fine, then inser...
Neville, regarding the VLAN issue:Did you tried to issue the command "switch trunk native vlan " on both sides?Regarding the STP issue:I do think that the answer is yes, you need to set STP parameters on switch ports, regardless if it is a multilayer...
