Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I have a setup where i have setup as followsServerfarm---ASA---IPS---ServersonVLANsI have configured VLAN groups on the IPS. I can reach the servers on all the VLANs from the server farm and i can also reach the Server farm from the servers b...
Hi guys,I am setting up a web vpn on Cisco ASA 5540, however when i run webvpn enable outside command i get the following errors which i have attached. i am using version 8.0(4).
Hi friends,I have a few issues with my CUCM 6.0 business edition installation and would like some help.One, how would i enable particular extensions to call other extensions anonymously, ie only name displaying but not extension number? is there a si...
Hi Guys,I recently had an IP address conflict on my network, a device was installed with the same IP address as my CUCM 6.0. The device was removed and the IP address changed but we have been having problems ever since. I can be able to reach the Cal...
Hi Guys,I have a new router that gave me an eror on bootup for the first timeafter readonly ROMMON is iniliasedit gives me the error device does not contain a valid FSboot: cannot open "flash:"boot: cannot determine first executable file name on the ...
BTW,The VPN does work. Problem is that there is no title page and i canot modify the portal page nor restrict user access to the resources on the LAN. Not even after setting group policies. Once on the web VPN everything is accessible which should no...
Hi Java,the call display restrictions worked. however i am having a problem i think with Calling search spaces as i cannot dial the phone with call display restrictions though i can call from it. This is only for internal numbers. for the direct outw...
Hi Gilles,i guess what i have is a client NAT, because i have created a group and used the "add destination service" command. Now i dont know if i have understood this well but if i want to NAT the server ip addresses i have to use the "add service "...
