Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several 2620's that I need to upgrade to 32mb of Flash. With the Flash upgrade, comes a ROM chip. The problem occurs when I replace an older ROM chip with the newer chip included with the flash. When we boot the router, we see absolutely no...
How many simultaneous tunnels can the PIX 515 support without the VPN Accelerator Card? Is there a difference between the 515 and the 515E?Also what determines the number of tunnels supported by a router configured for IPSEC? Thanks,Cosby
Is it possible to set up a centralized CSPM server to manage or control other CSPM servers that were originally set up as stand-alone servers and are on networks seperated by the Internet? We have installed several of the IDS/CSPM combinations in th...
Is it possible to both perform load-balancing and redundancy using one interface? I have the load-balancing portion working, but the redundancy portion is failing.Cosby ColemanTCCSI
Thank you for the reply. I am able to boot with existing ROM, but my concern is the documentation states you must use the 12.2(6r) ROM in order to upgrade a 2620 to 32mb. Is this the case?Cosby
How would this change if the scenario was 2 CSS boxes each plugged into a seperate L2 switch, but the same VLAN and with the L2 switches being connected to each other and the CSS boxes connected together via crossover for redundancy?
This is our current network diagram and it works. outside [router] | | dmz (10.10.10.x/24) [ pix ]-----------------------[L2switch]-----[L2switch] | | | | ...
Just to be sure I don't misunderstand you, are you saying that the IDS's promiscous interface should be connected behind the firewall's DMZ? Currently, we have that interface placed in front of our firewall in the DMZ between the firewall and our ou...
