I am trying to setup load balacning and failover over two WAN links on my 1811. One provider is cable and the other is dsl. Each has a modem and no pppoe/authentication is required. Also I have a single static IP from each ISP. I have a vlan that...
I just talked with my CCIE friend, who gave me some insight on why mine is working. I am using IPSec to protect the tunnel, so the PBR can work. Without the IPSec to go over the GRE I would see this problem.
What do you mean? At my main location there is only one internet connection, so the tunnel destination on both tunnel interfaces at the remote are the same. However, at the main location tunnel0 goes to one connection and tunnel1 goes to the other....
Not sure if this issue has been solved yet, but how about using a routing protocol over your tunnels? I am using eigrp over 2 tunnels for failover and load balancing. EIGRP hellos should check your reachability for each route.
