Is anyone successfully using Band-select ? I was reading the 6.0.182 release notes and found this comment:"Band Select and Load Balancing CLI CommandsThe config band-select and config wlan band-select CLI commands appear in controller softwarerelease...

We are working on assigning VPN clients IP addresses from different pools depending on which group they are in on our ACS server. We are looking to use the 'Assigned from AAA client pool' option on the group configuration page of the ACS, by specifyi...

I'm wondering if anyone has used the RF calibration model feature of the WCS where you take a laptop to a site and click on data points on a map.I'm trying to figure out if this is only used as a calibration if you are doing location tracking, or doe...

We're trying to set up a Site to site vpn between a 2851 router and an ASA. I'm trying to use the command 'crypto isakmp...' on the router and it doesn't recognize the command at all. I'm running version "c2800nm-spservicesk9-mz.124-13.bin" of IOS on...

I'm trying to set up a SPAN on a 802.1x port as the source. I'm trying to capture the 802.1x EAP conversation going back and forth and am only seeing one side of the conversation, from the host to the switch. I'm not seeing anything from the switch b...