Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is anyone successfully using Band-select ? I was reading the 6.0.182 release notes and found this comment:"Band Select and Load Balancing CLI CommandsThe config band-select and config wlan band-select CLI commands appear in controller softwarerelease...
We are working on assigning VPN clients IP addresses from different pools depending on which group they are in on our ACS server. We are looking to use the 'Assigned from AAA client pool' option on the group configuration page of the ACS, by specifyi...
I'm wondering if anyone has used the RF calibration model feature of the WCS where you take a laptop to a site and click on data points on a map.I'm trying to figure out if this is only used as a calibration if you are doing location tracking, or doe...
We're trying to set up a Site to site vpn between a 2851 router and an ASA. I'm trying to use the command 'crypto isakmp...' on the router and it doesn't recognize the command at all. I'm running version "c2800nm-spservicesk9-mz.124-13.bin" of IOS on...
I'm trying to set up a SPAN on a 802.1x port as the source. I'm trying to capture the 802.1x EAP conversation going back and forth and am only seeing one side of the conversation, from the host to the switch. I'm not seeing anything from the switch b...
If you are running 6.0.132 you can use the reporting feature.In the WCS, click on Reports - Report Launch Pad. Under the 'Clients' table there is a report called 'Client Count', click on the 'New' link next to that.Now you can create the report, unde...
You can use it without the wIPS. If you set an AP to be in sniffer mode, it will ask you to reboot the AP. After it reboots, if you go to that AP's interface configuration page(a or b/g), there is a checkbox that says 'Sniff' and after it is checked...
I've figured it out.1)On the ACS, go to "Interface Configuraton" - "RADIUS (Cisco VPN 3000/ASA/PIX 7.x+)" - Check the boxes for "[026/3076/217] Address-Pools" .Click OK.2)Under the Network Configuration button on the left,Set the 'Authenticate Using'...
I contacted TAC and we determined that when the 'Authenticate using' section of the devices network configuration was set to 'RADIUS (Cisco VPN 3000/ASA/PIX 7.x+)' the attribute 88 - framed-pool was not being sent to the ASA. Changing the 'Authentica...
