I'm installing a 5520 at a site that has 2 Internet connections. Both connections will run through the ASA.Is there a way to load balance outbound Internet traffic to use both connections?Thanks.
I have a 3750 at a remote location. I have it connected to an Avocent console server, so I can access it via the console. It currently has no image on it and only loads to the boot loader. I know that typically I could load an image through xmodem...
I have a router that has 2 Internet T1 connections. I would like to create 2 tunnels, one on each connection and have them go to a single 7201 in our data center.1) Is this possible?2) Is there a way to load balance or bind the tunnels together so t...
What would cause a Lost Carrier error? We've got 2 4506s that are showing 1 lost carrier on most of the ports.Just want to determine if this is something that should be investigated further or can be ignored.Thanks.
Is there a way through ACS to limit user logons to only specific devices? I know through NAR, I can restrict the source address, but how can I restrict the destination?Thanks
Ok, not sure what happened, but it started working again. The only thing I could think of is that a session may have been hung and was blocking the switch from using the tftp port.I rebooted my PC (where the tftp server was running) and everything s...
I can ping to and from the switch and tftp server. I know the tftp server is working because I can connect to it from other hosts, it's just this one.Trying to copy from FTP gives me the same error.It seems that the copy command in general is giving...
One update if it will help. I've been doing some research and I found that ACS replication doesn't like NAT and replication will fail if the IP address is changed through NAT.While NAT is running on the firewall that our ACS appliance is behind, the...
The syslog server is getting plenty of other messages from this ASA, it's just this one that won't come through if I mess with the severity level.If I leave it at its default, which is level 4/warnings, it comes through. However, I don't want to log...