Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Have a small office I need to setup with a few requirements. I need to replace some unmanaged switches with one or two managed devices to better facilitate bandwith and general managment. There will be 5/6 VLANS (VOIP, Users, Wifi, CCTV ect),...
Hi All, First post!So i've acquired a 881 ADVSEC in the hope of going through CCNA at my own pace (and also to use as a home router). It came from a previous deployment so i've been able to reset the password, upload the current release of firmware (...
Looking at the basics of setting up a redundant ring with either fibre or copper links. Have been doing a fair bit of looking into the whole rSTP side of things and wanted to know what the consensus would be on setting up a simple ring with probably ...
Thanks Atif,Pretty much exactly what I was looking for on the Cisco front. Is there a reference for what Cisco products contain that technology? I've since only found it on the Catalyst 4500 series and have seen mention of it for the ME 3400 switches...
