Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Have the latest HUU 2.0(10b) and have tried the following ways to update the firware, with no success:
a) KVM mapped DVD - too slow
b) USB Boot - displays message that firmware cannot be copied.
USB boot is the preferred method as it just fast...
Hi, I have a Cisco C220 M3 server with a VIC 1225 card installed which is running ESXi 5.5. We have a pair of 7k's with a vpc peer link. The 10gb ports on the server are split between the N7k's. A management vswitch is configured, with both nics ...
Hi, I hope someone can helpWe have 2 separate UCS installations, identical hardware config; 2, FI's, NetApp direct-attached storage, and upstream HP switches. I have one installation up and running, iSCSI boot working fine.The other ins...
HelloI am trying to remove an uplink from an IOM to the fabric interconnect as its not required. I have tried to reset the I/O module and re-acknowledge the chassis with no luck, it is still shown in the GUI with the error message as in the subject....
Hi Karthic
I used Rufus to start off with, then moved to unetbootin, both had the same issue.
HUU starts fine, and then displays 'copying firmware and tools' (i think), and then a dialogue box appears stating that the firmware could not be copied. ...
Thanks Wes, however using HUU was my original issue. Using KVM-mapped DVD was way too slow (after 40 minutes, it was still loading and I never left it long enough to carry on), and via USB boot it displayed a message stating the firmware couldn't be...
Hi Amit, below is the config from the n7k. I have also attached the networking config from the ESXi host. interface port-channel 19 description *** EXSi server *** switchport switchport mode trunk switchport trunk allowed vlan 8,9 spanning-tree...
I came back to site this morning, booted a blade and got the Option ROM sucessfully installed message, having made no config changes. I booted the vmware installer, however it still could not see the LUN. I could see the session on the netapp though...
