06-18-2012 03:02 AM - last edited on 03-25-2019 01:37 PM by ciscomoderator
Hello
I am trying to remove an uplink from an IOM to the fabric interconnect as its not required. I have tried to reset the I/O module and re-acknowledge the chassis with no luck, it is still shown in the GUI with the error message as in the subject. We are currently running 2.0(1s). The kit isn't in production yet.
Thanks for any help
Solved! Go to Solution.
06-18-2012 05:33 AM
Hi barry,
The only way for you to clean that up will be to de-comission the chassis in question and re-add it back.
Thanks!
./Abhinav
06-18-2012 05:33 AM
Hi barry,
The only way for you to clean that up will be to de-comission the chassis in question and re-add it back.
Thanks!
./Abhinav
06-18-2012 05:46 AM
Excellent, thanks for that. It seems a pretty heavy handed approach to clean that up. If that config was left, would it cause issues...apart from the error message?
Thanks again
06-18-2012 05:48 AM
Yes i agress thats a pretty heavy approach to clean it. No if you left it there as it is, there would have been no operational issues. It would have just left this fault in the UCSM.
./Abhinav
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide