Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a doubt about security zone in firpower, if I change the name of a security zone, will the firewall automatically change all the rules that contains that security zone? I don't know if this is obvious but I can't find an answer.
Hi! I've been trying to get a REST API call to work with no luck, I wanted to get the hit counts for all rules in an ACP, I see that I need to give a Device ID but I've tried the FTD HA Pair ID, and just the devices ID and evertime I get device Id is...
Hi, I recently created a routed STS VPN against Azure, tunnel comes up but the traffic is being dropped when the communication starts at the side of the ASA, asp captures for traffic that should go trhough the tunnel shows the following messages ...
Hi! I'm planning a firepower upgrade from 6.4 to 6.6 and need to add a rollback procedure, and was wondering if I needed to re-image the device or there is something easier like uninstalling a patch?
Hi, I've been looking but can't find a place to automatically update the umbrella network by using the dynamic address of my mx, integration says I should do this at the bottom of the general page in my meraki network but I can't see the optionAny id...
I was not able to find the root of the problem but we did manage to get the routed VPN working We used the BGP IP of the Azure configuration as the next hop in the tunnel for its own subnetroute Azure_tunnel 10.0.9.0 255.255.255.0 10.0.9.14 In our ca...
Thanks for that response! I'll try to see if the client can open a case with Cisco before the next session to see if they can help.In any case, policy based worked without a problem? Provider told us they had an issue with another client using ASA an...
