Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Doing a search on Google to find the purpose of the Order bit in the 802.11 header (subfield of the frame control field) only provides a generic (not helpful) explanation of how it's used for stict ordering of the fragments/frames. Fine, but what doe...
Example: arp 192.168.100.1 0000.000c.2345 arpaWhy when using the above command must you specify the encapsulation type if that is already defined at the interface?
The speed of the link is not determined by the bandwidth command. The actual speed of the link is determined by the clockrate set at the provider side(DCE).On your serial interface you could use the bandwith command to change the BW value to 100000 K...
Latency will depend on how far the traffic is going and how many nodes it travels through. If the other end of the VPN is on the other side of the world then the latency will be more than if the other end of the VPN is across town. Latency is smaller...
By default, summary LSAs are not summarized so you would need to provide the mask information to get a proper answer.If you're asking about classful addressing then those two networks do not overlap. One router is advertising 192.168.0.0. This is a c...
