Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to configure a ASA so that traffic for a internal server say 192.168.1.250 port 8801 can be accessed using the public IP. I want only specifically the ports needed to be routed to this internal server address. If I add a static NAT route in th...
We have some SPA525G2s that are losing registration randomly. They are connected to a UC320 and SG500 Series switches. They're on the correct VLAN and the UC sees the switch as a CDP Neighboor. It's occured both with a hardwired phone and a wireless ...
Is there a way to have two line buttons for example on the phone and a single SIP Provider to have the phone system show a different outbound caller ID depending on which button is pressed.For example right now they have 3 analog FXO lines. So they j...
These guyshttp://www.2n.cz/en/products/intercom-systems/door-and-security-intercoms/helios-ip-vario/ Tell me their product is compatible with the Cisco UC320 and SPA525G2 phones it just functions as a voice endpoint. Cisco has also confirmed this. My...
Is it possible with the SPA525G2 to program my user to be able to view status of airports and flights? Can you link the SPA525G2 to external XML pages like that? Does such a service exist?
I believe this would do the same as what I mentioned in ASDM? It seems if you don't specify a port when doing the setting in ASDM it works but as soon as you do it by specifying a port it doesn't work. Would there be an ACL or something preventing it...
Hi,
The interface would need to be inside, inside would it not?
We're trying to access a server on the internal network but use the public IP address. So hairpin, the ASA needs to take the traffic say from the LAN Network on a device which is access...
Unfortunately we tried the factory reset also before. The only thing we haven't tried is running them with a Cisco WAP. However without shelling out some cash there's no way we can test that. It seems to be limiting if they require you to use it on C...
Can't be a very basic configuration if no matter what we try wont work haha. I've double checked tripple checked and quadrouple checked. We have the settings correct. The access point is Vortex with a capital V, the security is set to Open, other sys...
We've tried with no authentication is the problem no matter what we set no encryption, WPA1, WEP and it just sits at the screen trying to connect. Also it is the 7920, I'll see if there's a specific model listed on it but it'd be the US one. It seems...
