Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is a vague question but I guess I need to start somewhere.In a smaller sized environment, I see the following counters on a 5510 w/ a CSC module...Frame drop: SVC Module does not have a session (mp-svc-no-session) ...
HelloI noticed that the LDAP Monitoring Service keeps restarting, daily it seems.Since none of the other services have been restarted in months I find it strange this one is. Is this a normal behavior.I am having an issue with a CCX Agent that keeps...
I have a VLAN 6 that is dedicated to a Partner organization (they share our bandwidth and schedule conference rooms with our Exchange).Question is how do I configure ACLs to direct ALL traffic to and from Partner, exception of accessing our Outlook W...
When setting up a subinterface for a VLAN...What do you set the security level at for the actual interface?As seen below, I've managed to do two different things.Intially I didn't know what I was doing...bet you hear that alot. 1) Ethernet0/1 the a...
I've been scratching my head on this but keep getting a little mixed up.This is the deal, I used Acronis for imaging workstations. Obviously when I do that it drags everything down to a halt, as all the ports are being flooded with packets. So what...
Is there a workaround for this issue? We are currently using an older system version, 11.5.1.18900-97, and cannot upgrade because we do not have an active contract with Cisco.
Indeed, I suppose a really odd question...What I'm looking for is a "normally you don't see any counters for inspect fail unless there's a problem with ******, so you might want to look into ******"I have an exceptionally noisy network here with hit ...
I have a similar situation, ASA 5510 with a SSM-CSC-10 Module and getting very frequent 502 errors.Have you found any other clues or perhaps a solution?
Re: Outside-interfaceThat never occured then to assign a VLAN to the Outside Interface. I'll have to reconfigure...what...for traffic to flow properly.Also, again, what about the security-level on the physical interface? Does that interfere with t...
