Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a wireless client getting disconnected but I don't know what is causing the disassociation. Problem is, the client gets disconnected while the customer is working - it takes some time to reconnect, cause the WLC / client is stuck some time in ...
Hi ... I did an upgrade from 1.1.4 to 1.2 and run into same issue 1.) backup schedules. Can you acknowledge, that you do not have this issue with fresh install ?
thanks for hints - that's some work. I will start monday, out-of-office for 3 days.Event Driven RRM is off - I know it. Clean Air is enabled. I will try to debug AP / Client in parallel and follow some steps you described, thanks so far to all. I...
One more info. The customer said the problem started with switching to 7.2.103.0 code on 5508 controllers. We were on 7.0.x code with 4404 before and are actually migrating. So 35 are on 5508 - 130 left on 4404. The infrastructures are seperated conc...
4.) 4 x 1242 and 1 x 3502 means on this floor. There are more neighbours, but the ones on the floor are DE-WK1-E2*. The 3502 is the only one nearby. I also thought about a mixed 802.11g / 802.11n Problem, as the 1242 are bg and the 3502I has N enable...
I can post it - no access right now. Will do on monday. But those events I posted in the beginning of the thread are the first ones while the client was on "debug client ".I also thought about an AP event as stated by the message. Question is : How t...
