About k.hart

k.hart · 08-27-2002

When configuring ISIS in a multi-area environment I have a questionWhy would you set the first ISIS process to be a L1L2 and not just a L2?I've been reading some documentation on CCO and it says the first area should be a L1L2.see below for config !r...

k.hart · 08-09-2002

Hi allAnyone have experience with Multiarea ISIS routing. We are doing this in a DCN environment and need to configure partition avoidance, but this does not work. Any help would be appreciated.From the config below, if we lose full connectivity wit...

k.hart · 05-01-2002

Question How many L1 OSI areas would you expect to support on the following platforms? Within each L1 area the number of Network elements is expected to be around 10-15. The Cisco docs say that you can configure a maximum of 29 level 1 areas. 2621 36...

k.hart · 05-01-2002

QuestionHow many L1 OSI areas would you expect to support on the following platforms?Within each L1 area the number of Network elements is expected to be around 10-15.The Cisco docs say that you can configure a maximum of 29 level 1 areas. 2621364036...

k.hart · 04-10-2002

HiI'm just starting a new project to build a new DCN network and require info on CLNS routing and Multi-Area OSI routing. I've some experience with CLNS routing in a single area, but not with multi area routing.The plan at the moment is to us IS-IS f...

k.hart · 08-09-2002

Donyou say the following "only one interface is allowed to be in each L1 Area"My understanding of this from the link you provided, is that an interface can only be part of one L1 area. Do you agreee?i.e would it be possible for the following to be ...

k.hart · 08-09-2002

yes, if AREA100 looses all it's L1 adjacencies, it is still advertised.IOS is 122-6

k.hart · 06-12-2002

HiHow about creating a unix script to change the passwords using snmp. This script could be set up to change the passwords on a weekly/monthly basis using cron.I've created some scripts to fetch the config from multiple routers using snmp, to make c...

k.hart · 06-06-2002

Andyip nat pool nat 10.10.10.3 10.10.10.3 netmask 255.255.255.240 -> is this correct?Try changing your config to the following.interface loopback0ip address 10.10.10.3 255.255.255.255.!ip nat inside source list 1 interface Loopback0 overload!

k.hart · 05-09-2002

Hi RussI've seen in Cisco documentation, for example the Cisco 2621 supports 3 L1 OSI areas, the part I need to know is what number of network elements is this number based on. I've raised this with the TAC, but I don't seem to be getting the answer...

Member Since	‎10-17-2001 09:23 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	20
Total Helpful Votes Received	4

User Statistics

User Activity

Multi-area ISIS config

Multiarea ISIS

How many L1 OSI areas would you expect to support on the following?

IS-IS Multiarea config for routing clns in a DCN

OSI CLNS router config for DCN network

Re: Multiarea ISIS

Re: Multiarea ISIS

Re: Passwords - Is automatic password update on multiple routers

Re: Overload NAT Problem

Re: How many L1 OSI areas would you expect to support on the fol