Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am experiencing slow internet connection. This week I upgraded my connection to 50/10 but when I run speedtest I am only getting 10/5 (which was my old speed).
These are some of the commands I've run:
sh int e0/0
Interface Ethernet0/0 "", is u...
I might not have chosen the correct community, but anyway: I have four static ip-addresses and I have ASA 5505 with a basic license. How do I tell that outside a.b.c.100 shall be directed to x.x.x.10 inside? (if that is what I want of course)
I see in my history that I had a similar problems a while back, unfortunately I had to nuke the setup and so I am sort of start of from the start again.I have two servers set up in DMZ, one FTP and one WWWFTP = 192.168.2.101WWW = 192.168.2.100Outside...
Dear all,About two years ago I (finally) had vpn set up, but I had to nuke the setup a while back (to long ago to remember why).My setup:Cisco ASA-5505 on-board accelerator (revision 0x0)Base license.Cisco Adaptive Security Appliance Software Version...
Dear forum,For some reason there are some sites that I cannot access websites from inside interface.One such example is lxer.com where I am receiving this message in the browser:The connection has timed out The server at www.lxer.com is taki...
So reading an article on input error and crc where one of the reasons for the high number of errors and crc was that duplex on the asa was set to full, while the modem/router was set to auto. I changed all settings from full to auto on all ethernet p...
This is after the clear interface ethernet 0/0 command and after running some 2 minutes or sosh interface e0/0Interface Ethernet0/0 "", is up, line protocol is up Hardware is 88E6095, BW 100 Mbps, DLY 100 usec Full-Duplex(Full-duplex), 100 Mbps(100 ...
Interface e0/0 is the outside. So it is connected to the modem.Here are the same stats some hours later. I shall see if I can clear the interface counterssh interface e0/0Interface Ethernet0/0 "", is up, line protocol is up Hardware is 88E6095, BW 1...
E0/0 is connected to the "modem"/router. I did a clear traffic after the upgrade, but don't know how to clear other things.
I took one computer out of the network and connected it directly to the modem/router and it got 50/10, so there is something w...
Dear Marvin,Thanks for your valuable feedback.What I am trying to achieve is this:I have public IP "1.1.1.1"-"1.1.1.5".Outside is set to 1.1.1.1I have the following zones:inside (machines has 192.168.5.1-20)outside (1.1.1.1)dmz (machines has 192.168....
