Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am fairly a newbie to the ASA 5505, and I'm currently only familiar with ASDM to configure this thing until I get some classes under my belt.My question is this... We have a 5505 and I have configured a separate inside and guest network. Vlan 4 is ...
I have an ASA 5505 with Security Plus LicenseAny help would be appreciated on the scenario below. I'm more familiar with asdm gui than command line.I have 5 Static IP Addresses from my ISPI have the following interfaces. Outside (vlan 2) / Inside (vl...
I have an ASA 5505 with Security Plus LicenseAny help would be appreciated on the scenario below. I'm more familiar with asdm gui than command line.I have 5 Static IP Addresses from my ISPI have the following interfaces. Outside (vlan 2) / Inside (vl...
I am having all sorts of trouble connecting a Cisco RVS4000 to a Cisco ASA5505 over IPSec... I have used the "site to site" vpn wizard, I am new at this time so any advise would be good. I have a fress "factory reset" on my asa 5505...
I'm fairly new to cisco and the ASA 5505 I have the asa connected to the internet on 0/0 I have a computer connected to port 1 and on port 2 I have a netgear router. the asa is 192.168.1.1 and the netgear router is 10.1.5.1 I cannot get the compute...
So using the ACL in your example will allow inside 192.168.26.1 to communicate to 192.168.27.2 but prevent any client on 192.168.27.X to communicate to the 192.168.26.X network?Sent from Cisco Technical Support iPad App
So the following setup like you provided in your last post will allow my inside network to stay on the same outside public ip which i specified as the outside static and then provide the guest network another outbound outside address
When I am trying to configure this in GUI I already have an inside-network/8 and a guest-network/24 do I want to modify them or do I create a new network object as you specified? Is this below configuration translating rightobject network INSIDE-Subn...
