Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone!
After factory reset via usb flash of VSMS, the redhat linux doesn't allow to log in. Ip Address was obtained as normal 192.168.0.200, but the password root/secur4u doesn't work. I'm tried a dozens combinations, but it doesn't help. We ...
Hi everyone!
I have a problem with one agent in UCCX. This agent once or twice per day getting automatically logout from Desktop Finesse, sometimes directly after call ends. Reason code of the logout is 255. This user is only one, who have this probl...
Hi everyone! I have a problem with port frowarding to my IP camera from internet. My configuration looks good, but the port forwarding doesn't working from Internet. Config is below: Interface GigabitEthernet0/0.666vlan 666nameif IPCAMsecurity-level ...
Hi everyone!
I have the critical status of the software on the one of VSM servers. I checked the logs, and there was an error "recorder_oversubscribed". In the groom logs presents errors related to oversubscription. When i checked status of the repos...
Thank you Adam very much.
Root cause of the problem is the installation process with 7.0.0 version. After trying to install 7.0.1 the passwords works as expected.
Hi,We are replaced the PC of the agent and seems the problem is gone. We'll monitor this problem the next week, and if happen again, i'll share the logs here.
Hi everyone! The root cause of the problem was in the nat rules. My manual nat blocked my auto nat, so solve the problem is after-auto in the manual nat command.
Hi Flavio! Thanks, for you reply. When i try to use camera's IP address, i get DROP on NAT with rfp-check: FW1# packe input outside tcp 111.11.50.218 8090 10.10.7.130 8090Phase: 1Type: ROUTE-LOOKUPSubtype: inputResult: ALLOWConfig:Additional Informat...
