Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,since we have add a new Catalyst 2970 for our servers non Cisco clients (like Intel High Rate Wireless LAN Mini-PCI Adapter with Modem II - IBM Thinkpad T30/T40) connected to AP350 (VXware 12.5)can not see any host attached to the new switch...
Depending on the %PIX-3-201002 message I've tried to configure nconns. using the following syntax:static aaa.bbb.ccc.xxx aaa.bbb.ccc.xxx netmask 255.255.255.255 nconns econnsUnfortunately w/o any success. May somebody know how to do that.
Well that's what I have found by myself. But only 4500 Series is shown with. May it depends on EOL of 4003. It's a very critical costumer so I wonna make 100% sure.
Thanks Glen, may you can send me the link? I need to know if CatOS 7.2 will run with 4003 because I have seen that it will work with 4503.Regards from Munich, GermanyAxel
thanks a lot. that's what I've done during the morning. I have also tested the new config sending a email to about 300 receipients without any problem. Do you think no limit for econns is dangerous in case of SYN attacks? Some commands like sho perfm...
There is a MS-Exchange Server sending a growing bunch of mails, sometimes about 3000 a day. The server have more and more problems to deliver the Mail in time. SMTP log says "Unknown Host" at the same time PIX Syslog says "PIX-3-201002....".I do not...
