Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have many 2501s connected via Frame Relay to two core routers. All of the sites show up when running the command: "sh ip eigrp neighbors"...except one. I can ping the router but can't login. TACACS+ fails due to this apparent EIGRP failure or pr...
Without upgrading these switches to 12.0 or higher, is there anything that can be done to allow these devices to be configured to Authenticate to ACS 2.6?
Understanding how large these logs can be I would like to incorporate a scrypt to pull important or critical information out each day. Is there a site that list standards for things to look for daily?
After successfully implementing Cisco Secure ACS v2.6, I noticed an error in the "FAILURE" logs for one of the 5300s. It states "dnis:974xxxx Authorization failure...user unknow". This device pools lines into an ISDN incoming line. It seems everyt...
I would agree on the hours but not sure on the hourly rate. I would tend to agree with the theory of geographical area and number of resources available. Post your concensus on hourly wage or even email it to me too.
Many products out there..all depends on budget or what you really need. If you simply need discovering agents and such, I would suggest downloading something like Solar Winds. Offers much information at a very low cost. I have used many others tho...
Why would the UDP EQ 80 block a telnet application (i.e. 23) or the ability to ping? This seems to be the case but I will test it very early in the morning tomorrow before anyone arrives.
