About ben.langberg

ben.langberg · 01-15-2018

Hi All,Quick question that came to mind over night.In a hub and spoke environment where the spokes are only hanging off a MPLS link back to the data centre with no internet and rely on accessing Meraki cloud via the hubs (data centres) internet, what...

ben.langberg · 12-13-2023

Further test to confirm MA-CBL can be used for 1G / 10G mixed. MS225-48FP SFP+ port >>> MA-CBL-3M >>> MS220-8P SFP port came up once I changed the link negotiation to 1Gbps

ben.langberg · 12-13-2023

Hi Baka, I understand there is a official datasheet however, I have had mixed results in the past and have had the MA-CBLs come up at 1Gbps line rate. Image attached, I have a MS210-48LP uplinked via its SFP port using MA-CBL-TA-1M into a MS410-16 SF...

ben.langberg · 02-24-2019

Hi SCC,There is probably a few ways to do this.As the Nighthawk is essentially a router you could setup a separate VLAN just for your phone(s) to communicate to it as their default gateway rather than the MX68.

ben.langberg · 07-31-2018

Hi Silas1066, The other option you have is to request Meraki support upgrade that network and device to 15.9 No-NAT beta release. You then have the option to disable NAT on the interface that is facing your MPLS Network. Regards,Ben

ben.langberg · 07-17-2018

+1 on those two wishes. I've put these in before to Meraki

Member Since	‎11-13-2016 09:25 PM
Date Last Visited	‎06-21-2023 03:27 AM
Posts	14
Total Helpful Votes Received	6

User Statistics

User Activity

Auto VPN over MPLS and loss of Internet

Re: DAC cables for MS120 switches - MA-CBL-TA-1M and MA-CBL-TA-3M

Re: DAC cables for MS120 switches - MA-CBL-TA-1M and MA-CBL-TA-3M

Re: MX68 - LAN Port - Telstra Nightawk

Re: NAT exemption / No Nat functionality on MX84

Re: MX65 Connected Devices Upstream