I've set up a lab with 2 2501s connected via dte/dce serial connection. One side of the "WAN" is on the 10.10.10.0, the other is on a 192.168.0.0 network. From the 10 network I can ping S0 and E0 on the 192 side. Also, I can ping the default gatew...

I work in a CAD-intensive network with Cisco Catalyst 3560G switches. We have a rack of 5 switches that feed a floor of users and all the servers and all the feeds from the other 3560s on the 3 other floors. The 3560 are all GB and I have CAT6 conn...

I want to TFTP the run config. to my laptop. The switch is not yet on the network. How do I copy the run to my laptop through COM1? Thanks.

Hello,Recently, while configuring a lot of Cisco 2940s, we patched the swiches into an rj-45 at our desks and immediately brought down half of our network. The network recovered in minutes after pulling the switch off of the network. We have a host...

It would greatly help in instructing non-technical types around the world in our org. to connect networking equipment if we had pics or diagrams of the back of several Cisco products we use. Does anyone know if these are available?Denis