Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Can someone point me to a document / URL which lists the maximum configurable console baud rate for the catalyst series switches, especially the 65xx / 45xx platform? I would also like a document which helps in configuring the baud rates.
We are evaluating the use of the Catalyst 4948 / 4948-10GE switch at the access layer of our Server Farm. The distribution layer will be a chassis based solution.Is this a good choice? Can this switch satisfy all the requirements of a High Performanc...
Hi all,Need some help on isolating output drops on one of our E1 links. The links are terminated on Cisco 3745 routers on both sides, and the peak link utilization is around 60%. The links are tested clean. There is no pattern to the drops. The link...
Hi all,Is it possible to replciate the configuration of a PIX failover bundle across a wan link to another failover bundle? The idea is to set up two exits out of our network. While traffic can be re-routed in case the primary gateway fails, our conc...
Hi,I work in a fairly large network with a pair of Cat 6513's with MSFC-2 in HSRP mode at the core. Cat OS Version 7.4(3) and IOS version 12.1(13)E6 on the MSFC. The access switches are all Cat 4507's with Sup IV modules with IOS version 12.1(13)EW....
Catalyst 65xx platform with Sup 720 is a good choice. Even with the Cat65xx / Sup 720 combo, you need to invest in Fabric enabled line cards like the WS-X6748-GE-TX with Distributed forwarding cards (WS-F6700-DFC3A) to get the full rated performance....
Fully agree on the Backplane capacity. That is the reason we zeroed in on the 4948 when looking for an access layer switch in the data centre.My query is about the Uplinks. With 48 servers pumping data at a therotical 2 GBps (full duplex), would a 8 ...
Thanks for the prompt response. The concern was not about the backplane or the ports. When fully populated, we can expect 96 GBps of traffic from the switch ports. Using 4 SFPs will give 8 GBPs of uplink bandwidth, that is a 12:1 oversubscription. Us...
I assume you mentioned LAN based failover. Replication needs to happen between primary and secondary firewalls in the active site, AND then replicate to the failover bundle in the DR site.Is this feasible, or do we need to place one firewall of the f...
All the outputs listed in the url have been sent to TAC. I think we can eliminate bugs also, since we have upgraded the IOS twice. Any inputs on how to track down a worm?
