Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good dayI would like to know if it is possible to add more output requirements when doing i.e. a show run command - "show run | incl ip route". for example - show run | incl aaa <and> ip route.Is this possible?Thanks
Hi allRouters connecting through a LAN switch - the one router can connect to the rest of the network through two gateways. HSRP cannot be used on the gateways due to the restrictions of HSRPv1. Now we are using a static route through the primary r...
Hi allI have a problem on a Catalyst 4506 with the tri-speed blade. The port is forced to 100MB and FD, with the host forced as well, but the port stays down (not connected). When I change both the CAT and host to autonegotiate, port comes up. When ...
Good dayI have a problem that needs a solution, and I hope someone out there can help me I need to be abe to do NAT for data going from the a customer VRF into the Internet VRF.I've leaked the routes between the two VRF's, configured the NAT statem...
Hi allIs it possible to block workstations on a lan from seeing the HSRP messages going between the routers? The scenario is 2 x 7200 routers configured for HSRP each connected to a 2950, which are in turn connected to each other.Thanks, Henk
HI JonAnother question. Is it possible to do a search or show to display lines with two options?i.e. show routes to a specific next hop?sh run | incl ip route <&> 10.1.1.1 ?ThanksHenk
HiThe requirement is from the customer that workstations shouldn't see any HSRP messages, etc.I will try the switchport block mc command.Thanks for the tip
