Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a 3560v2 switch and i cannot set the baudrate back to 9600 , (i tried lin con 0 , speed command) but after reload the switch it goesback to 38400and tried (unset baud) & set badu from rommon but no thing how i save the baudrate to 9600 even wh...
i have WLC 5505 with 100 AP joined and up and when i check the number of up access points in the summarry page it is 100 up and 0 down, but when AP is down and i check the summary it is 99 up and 0 down.the question how to know which AP is down and w...
i really donot know if QBSS and TSPEC can be used together at the same time in the WLAN (access point send the beacon with the QBSS then the client use the TSPEC) or i just choose only one option (QBSS or TSPEC) in the WLANdoes TSPEC and QBSS work wi...
i have 2 6509 switches configured with VSS (distribution) and i want to connect the edge switches (3560) with multichassin etherchannel (2 uplinks) but when i type #show etherchannel port-channel command on the 3560 switch all i get is zero va...
this is from student guideYou can enable WMM, thus sending the 802.11e standard QBSS Load IEs for nonproprietary Cisco phones and check the AP CAC limit box to replace it with the Cisco IE for the Wireless IP Phone 7920 and 7921G phones. The various ...
thx SAR for ur reply but i have another question does TSPEC work on 802.11b/g/a or just on 802.11aand QBSS works only in 802.11b/g but doesnot work with 802.11a ????
