Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,I have 2 locations, NJ & NY, i have a P2P link and OSFP between the two over 2600 routers. I also have FW-FW vpn tunnel over 5505.I have 2 vlans in NJ, vlan1 with 192.168.1.x subnet, and vlan10 with 192.168.101.x.Problem: I cant ssh to ma...
HelloTeam,How can I add a statement on like the one below for OSPF. I would like to add the statement as follow: O 192.168.3.0/24 [110/11] via 192.168.101.5, 3d00h, FastEthernet0/1.I just can't seem to find the right commands.O E2 192.168.6.0/24 [...
Hello all,I need to configure NAT (ip nat inside source static 172.x.x.x. 202.x.x.x route-map voicegateway), but can't seem to find the right command.I find the command: sh ip nat translations, but can't find the command to configure, not in the glo...
Do you happen to have or direct me to a config of OSPF and loopback interface on layer3 switch (WS-C3560G-24TS) using VLAN. I know how to do on a router with Serial and ethernet interface, but not on a switch where i have to use the Vlan interface t...
Hello everyoneQuestion: i have bgp running on a layer3 switch to provider A, and now im trying to configure ospf with /30 and /32 loopback ips to provider B's mpls vpn network thru a cat5 handoff. Can I configure ospf on that switch if its already ...
Thanks Alain,Just want to make sure you did not leave anything out. It seems you meant to give me further instructions when you say: Then you'll have to go on 192.168.101.5 and issue.Just checking., If you got something else to add, it will definetel...
Sorry about that.I have BGP running on that switch to my ISP provider which i do not want to touch, I have about 6 VLANs distributed in for different network segments. I now need to connect to a 2nd provider thru a cat5 hand off which i plugged into ...
