Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am runnning in monitor mode means "no access-session closed" applied on the template of the switch.However when I run "sh auth br", there was no active sessions. Is it because the switch is in monitor mode?
Hi, I have a voice device. It connected to a voice vlan. But there is no "int vlan 10" in the config. However it is getting IP from vlan 1. When "sh mac address-table", it falls under vlan 2. But "sh ip arp", it falls under vlan 1.May I know what is ...
Hi, May i try to understand wht these prepend command means in layman term?Why adding ip prefix-list Prepend-list-1 and ip prefix-list Prepend-list-2 below? R1274-R1no ip prefix-list Prepend-list-1 seq 1 permit 10.17.5.0/24ip prefix-list Prepend-li...
hI, It seems the Radius DEAD and ALIVE logs were occuring every few minutes. User complains it affect their access. However I thought when AAA down, all hosts will be AZ (authorised)? It seems AAA servers intermittent reachability frm the switch affe...
Hi, I am trying to configure primary and secondary route with pref 1 and 2.The objective is to always use primary route gateway 10.1.1.1. and Only use secondary gateway 10.1.1.2 if primary is down.On top of tht, I also have a default route 0.0.0.0/0 ...
Hi,I attached the switch dot1x config. Pls help to advice wht needs to be done. Only output is No sessions match supplied criteria andNo Auth Manager presence on this interface. Pls help!!!sh auth brNo sessions currently exist sh auth session int Gi1...
All switches configured with the correct same script. The ports are configured with dot1x template and sh int status shows port connected. However sh auth br or show access-session display no live sessions. All switches configured with the same scrip...
Hi, Does it means tht for config above in R1274-R2, "ip prefix-list Prepend-list-2 seq 5 permit 172.16.1.32/27" means traffic destined to 172.16.1.32/27 will goes through R1, Since the prepend command is in R2? Theoretically wht happen?
