Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For a customer we are using xconnect / Ethernet over MPLS between two sites, were the SVI is located on one site. The customer wants to migrate towards an SD access solution and still needs the "xconnect feature" between those two sites. If the two s...
we are building an SDA network with two Cisco9500 Border Nodes that are connected by BGP to a fusion firewall cluster (Fortigate). When DNAC configures the L3 border handoff it uses a /30 subnet between the Border Node and the external device, in my ...
Hi, is it possible to do a one to one vlan translation on a Nexus 9300? The Nexus is running in NX-OS mode and VXLAN is not enabled. With the switch port vlan mapping command i get a warning message: hostname(config-if)# switchport vlan mapping 10 20...
Hi, i have a question about the number of intermediate nodes in a SD Access fabric. Can i add two intermediate nodes behind each other? So you would get: Location A Border Node --> Location B Intermediate Node --> location C Intermediate node --> Loc...
Hi, for a customer i'm trying to authenticate anyconnect using an AD, but i can't get it work. On the Cisco ASA is see the following messages: Mar 23 15:02:07 [SAML] consume_assertion: The identifier of a provider is unknown to #LassoServer. To regis...
