Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!In my test environment, I'm deploying a C9500 as Border Node, connected to a Fusion Router (C9300) and a C9300 as the edge device.I did LAN Automation with the Fusion Router as the seed.The process went as expected, the C9500 and the C9300 were di...
Hi!As the title says, once I configure the Loopback0 interface and change the Management IP in DNAC to use the Loopback0 interface, operations on the switch become really slow (Resync, provisioning...).Simply adding the switch to the fabric as a Bord...
Hi,I've bee trying to get LAN Automation to work, but I'm running into some issues.I have 2 C9500 that are connected via trunks to a pair of C6800 in a VSS. They have a VLAN configured, with an IP address, that is used for management.I use one of the...
Hi,I'm trying to integrate the Meraki Dashboard in DNA Center (2.3.5), but I'm running into some issues.In the "Add Device" screen it asks for "API / Password" in the "HTTP(S)" section.If I input the API here, I can get the Organization details, but ...
Hi,I have a scenario where ISE controls VPN access from a ASA.Each user belongs to a certain AD group, and I want to configure different Authorization Profiles based on membership.Those profiles push dACL to the client.My question is if it's possible...
Thank you for your suggestions.What I ended up doing was creating an VLAN interface on both switches, and moved the physical interface configuration to that VLAN, then changed the physical interfaces to L2 trunks.
Thanks.I didn't discover the device. I provisioned it through PnP.So at the end of PnP, I have a vlan interface with the IP from DHCP, and a trunk to the upstream switch.At this point the management IP in DNAC is the vlan interface IP. I then configu...
Thank you so much for all your help.I know that this topic is very subjective to the individual topologies and scenarios.Nevertheless I'm trying to get as much information as possible.
Thank you for the clarification.Trustsec is not in place right now.One more question.The 6800 manages all our static routes. Can I safely activate and configure BGP without affecting traffic flow?
