Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Is it possible to configure NME-AIR-WLC6-K9 in ISR 2851 router into sepearte VRF ? Idea is to terminate wireless lan traffic into core switch and pass it through WAN optimizer ( Riverbed).Thanks,Gurvinder
I have question regrading GRE tunnel on 4948 switches. 1) Can GRE tunnel be configured on 4948 switches ?2) If yes , Is GRE traffic hardware switched on process switched ?3) What is the limitation/ through put for number of GRE tunnels ?Thanks in adv...
I am trying to find throughput of inbuild fastethernet ports on 2811 router. All I can find about is throughput for WAN connections (T1/E1) . Anyone has any insight on throughput capacity for following setup. Source-->>(FA0/0)2811 Router (Fa0/1)---->...
I am struggling with same issue with CME/SRST config as shown. ========telephony-service srst mode auto-provision none=========I think Dialplan-pattern only works for DID calls ( I am not even sure about that as I have not tested that yet), but it de...
